Download Lumenlab DIY Projector Guide v2.0 PDF

TitleLumenlab DIY Projector Guide v2.0
File Size856.7 KB
Total Pages41
Table of Contents
                            00_toc
		00_toc
01_disclaimer
		01_disclaimer
02_introduction
		02_introduction
03_fresnels
		03_fresnels
04_pj
		04_pj
05_light_flow
		05_light_flow
06_simple_optics
		06_simple_optics
07_better_optics
		07_better_optics
08_LCD_panels
		08_LCD_panels
09_stripping
		09_stripping
10_lamps
		10_lamps
11_putting2gether
		11_putting2gether
12_keep_cool
		12_keep_cool
13_enclosure
		13_enclosure
14_great_designs
		14_great_designs
15_comp_layout
		15_comp_layout
16_wiring
		16_wiring
17_screens
		17_screens
18_consider
		18_consider
19_keystone
		19_keystone
20_panel_control
		20_panel_control
21_parts
		21_parts
22_results
		22_results
Acr11222267.tmp
		21_parts
                        
Document Text Contents
Page 1

Welcome
Welcome to the Free Lumenlab Guide.



This work is licensed under a Creative Commons Attribution-
NonCommercial-NoDerivs 2.5 License.


Before reading into the guide, you should read the Disclaimer.

Contents
1. Disclaimer
2. Introduction
3. Fresnel Lenses
4. Projection Lens
5. Light Flow
6. Simple Optics
7. Better Optics
8. LCD Panels
9. Stripping an LCD Panel
10. Lamps
11. Putting It Together
12. Keeping It Cool
13. Building The Enclosure
14. Great Designs
15. Component Layout
16. Simple Wiring
17. Projection Screens
18. Important Considerations
19. Keystoning
20. Panel Controls
21. Parts List
22. Results
23. Conclusion

http://creativecommons.org/licenses/by-nc-nd/2.5/
http://creativecommons.org/licenses/by-nc-nd/2.5/

Page 21

Building The Enclosure



Simple projector enclosure design based on a 15” lcd monitor

The dimensions shown are what my first projector came out to be. I do not recommend you
use these dimensions for your enclosure because your components may vary in size and you
should carefully measure all of your components BEFORE cutting your enclosure. This is
probably the most basic enclosure you can build. The lens needs to be perfectly centered.
To ascertain the center, draw lines diagonally on your front piece as is indicated in the
drawing by the red dotted lines.



Centering the projection lens Cutting the hole for the projection lens

Page 40

Joe Werb’s Lumenlab projector

Tryn2havefun's Lumenlab projector

Similer Documents